Page 1 of 1
Volume of a timbre in combi mode
Posted: Thu Aug 26, 2010 8:53 am
by jankofron
Hi all, I would like to setup a combination and to increase the volume of a single timbre in the combi mode via one of the knobs while playing. Is this somehow possible? I found just a master volume control, however, I have two timbres sounding at a time and want to "boost" just one of them. I thought abou application of a filter, but have not figured out any reasonable solution... Thanks for any hints
. Jan
Posted: Thu Aug 26, 2010 8:56 am
by jankofron
Sorry, I forgot to mention I have TR 76.
Posted: Thu Aug 26, 2010 12:51 pm
by X-Trade
Solution would be the same on all triton models:
- Set one knob to 'expression' or 'volume' (expression goes from zero up to mixer set 'volume' level, whereas 'volume' completely overrides the mixer setting).
- Then set up the Timbre MIDI Filter pages such that only your timbre you want to control will respond to that knob.
Posted: Thu Aug 26, 2010 1:10 pm
by jankofron
Thanks a lot!
Posted: Sat Nov 03, 2012 2:48 am
by calois1
exactly what do you have to do to get the volume pedal to bring in the strings and leave the piano alone in a combi?
Posted: Sat Nov 03, 2012 2:49 am
by calois1
i should have said I have a triton Le