Page 1 of 1
OSC MOD broken?
Posted: Mon Sep 27, 2010 7:21 pm
by foodeater
When I press the osc mod button it disables sound, but if I use the screen to switch modes it works fine. I'm new to the radias and I'm not sure if I'm doing something wrong of if it's broken. Thanks.
Posted: Mon Sep 27, 2010 7:49 pm
by X-Trade
Does it do this with all waveforms or just with a certain setting?
What OSC Mod mode are you changing from/to?
Posted: Mon Sep 27, 2010 8:05 pm
by foodeater
Cross and vpm. If I int a new patch and hit the osc mod button to go to cross I get no sound. If I use the master program knob to go back to waveform still no sound. I have to hit the osc mod botton until I am back at waveform to get sound.
Posted: Tue Sep 28, 2010 4:48 am
by foodeater
This is pretty funny in Logic hitting the osc mod button turns on track muting.
Posted: Tue Sep 28, 2010 9:56 pm
by X-Trade
First of all try it without any MIDI or USB attached. Sounds like you may be looping some messages back somewhere which is affecting the sound.
Posted: Tue Sep 28, 2010 10:18 pm
by foodeater
Yeah, that is exactly it. I'm not sure what settings to change in Logic. I guess I'll have to do some more research. The unison button activates track solo and some of the other knobs are changing volume.
logigs clicks and ports
Posted: Wed Sep 29, 2010 10:17 am
by novac
you can set up what info logic will recieve and send in the setting section. plus if you go into clicks and ports you can had filters in to the midi signal befor it leaves logic, plus theres a arp and chord merory there as well to be played with and you can see all incoming midi info that you are sending to logic!