Korg Forums

I was just wondering if I can use the 4 Audio Outs as 4 Mono instead of 2 Stereo and therefore be able to have each timbre assigned to a different audio out?

I covered this recently in a thread here:
http://www.korgforums.com/forum/phpBB2/ ... ht=#351082

Anyway, the brief summary is "Of course you can! Just use the pan control for each pair". However, if you are using any mono effects like the amp simulation there is no post pan control on them, so it will force it to come out from the two outputs - annoying, I know. Also some other effects will effectively take over the pan because of crossover or whatever, like the pan and ping-pong delays, possibly reverb.