Korg Forums

I know this is a stupid question, but I bought a Korg Triton Pro X recently, expanded with the EXB-SCSI and EXB-MOSS, and want to remove them to put them inside my Korg Triton Pro instead.

However, I have been trying but can't remove the cables that connect each expansion to another board.
Is there any trick to do so?
I don't want to force it too much not to break it and I just can't see how to do it...

Any help would be really appreciated...

it should be simple, make sure you pull ont he side of the cable thats not on the MOSS.

i found it helped to unscrew the MOSS board, then just pull it out, came out nice and smooth for me

I could do it the same day.

I was trying to do that for the SCSI board and that one was the hard one...
I wasn't sure what should come out with the board, so I was a bit afraid of breaking something...

But with the MOSS board, after unscrewing it, it was much easier and after doing that I just did the same with the SCSI board.

Now I just have a small problem...
I lost some of the screws and can't put the boards back on my Korg Triton...
Anyone has an idea where I can get those screws?


Thanks

Paulo