Change Pattern instantly - no queue
Posted: Mon May 02, 2011 10:43 pm
Hi,
I'm sending the EMX a program change message (from an MPC 500) -- this puts the target pattern in the queue so it comes in on time next loop around.
Is there a way to switch off the queue/timing so it starts the pattern as soon as it receives the program change?
Even outside of using the program change message over MIDI, simply press play on a pattern then select a new pattern, it doesn't switch immediately.
Typically I know it's nice to keep it in time but I wondered if I can switch that behaviour off.
Cheers,
LW.
I'm sending the EMX a program change message (from an MPC 500) -- this puts the target pattern in the queue so it comes in on time next loop around.
Is there a way to switch off the queue/timing so it starts the pattern as soon as it receives the program change?
Even outside of using the program change message over MIDI, simply press play on a pattern then select a new pattern, it doesn't switch immediately.
Typically I know it's nice to keep it in time but I wondered if I can switch that behaviour off.
Cheers,
LW.