My Korg Kronos in PROG mode whats going on here?

taurgo Production · Post by **taurgo Production** » Sat Jun 11, 2011 6:55 am

can someone please tell why in PROG mode in the main play part when i click on the piano, to the right you will see a setup page then under that you will see a components page. now when you are in the component page everything is in red nothing works . the same goes for setup page the only thing thats in the black is the volume, pan, octave and transpose. i can't here the piano lid position effect release time, velocity time, velocity bias, or velocity intensity. iThe stereo perspective: Player is red also.

Did i load up the right sound in the hard drive or what?

When i went on Korg us web site i watched the SG1 video and his was working fine and they was all green not red like mine

MartinHines · Post by **MartinHines** » Sat Jun 11, 2011 11:16 am

Removed due to incorrect info.

danatkorg · Post by **danatkorg** » Sat Jun 11, 2011 5:41 pm

Parameters in red are assigned to tone adjust controls.
They will all still allow editing as normal, however. Try them!

- Dan

taurgo Production · Post by **taurgo Production** » Sat Jun 11, 2011 6:09 pm

what is tone adjust controls? and can i work them?

cello · Post by **cello** » Sat Jun 11, 2011 6:18 pm

Down on the bottom left of the control surface (where all the manual buttons are), there's a Tone Adjust button.

Press it.

You can now use the sliders to adjust the 'tone' or program.

taurgo Production · Post by **taurgo Production** » Sat Jun 11, 2011 7:12 pm

you can go there and see my problem.

http://www.youtube.com/watch?v=GDBtOini9k4

MartinHines · Post by **MartinHines** » Sat Jun 11, 2011 7:23 pm

I would suggest the following:
1) Go through the Easy Start Guide

2) Start reading the Operation Guide, reading 10 pages a day. Go through the entire book and you will be very comfortable using the Kronos.

Kevin Nolan · Post by **Kevin Nolan** » Sat Jun 11, 2011 7:32 pm

OASYS owner here and don't own a Kronos yet - Dan - that sound's like an excellent new feature. To know what's assigned to Tone Adjust - very nice and _very_ useful.

Kevin.

danatkorg · Post by **danatkorg** » Sat Jun 11, 2011 7:57 pm

Kevin Nolan wrote:OASYS owner here and don't own a Kronos yet - Dan - that sound's like an excellent new feature. To know what's assigned to Tone Adjust - very nice and _very_ useful.

Kevin.

Thanks - it's actually on the OASYS, as well!

- Dan

danatkorg · Post by **danatkorg** » Sat Jun 11, 2011 8:07 pm

taurgo Production wrote:you can go there and see my problem.

http://www.youtube.com/watch?v=GDBtOini9k4

I think it might be worthwhile to take a little time to read the manual, as Martin suggests. In the video you change the damper noise level and then play a few notes - but the damper noise happens when you press on the damper pedal. You then reduce the mechanical noise; this is a pretty subtle noise which occurs at the end of the notes. My guess is that everything is working properly!

Hope this helps,

Dan