Korg Forums

Hi,

I'm trying to use the audio inputs of the R3 to filter an external audio signal

I'm using preset P8 (labelled audio input) and that works......

.....but it seems only the input of the 1st audio input is used resulting in a mono-output (whereas my signal is stereo)

Is there a way to use both inputs as a stereo signal?

Thanks a lot

Erwin

(PS the signal also sounds a lot different, EQ-wise and perhaps already a bit distorted, although the input signal isn't overloading. what can cause this?)

A.) Make sure the back of the unit is switched to Line and not Mic.

B.) Make sure the Unison parameter is enabled an put the Unison Spread parameter at 127.

C.) ???

D.) Profit.

ps make sure the mic switch on the front of the unit is set to REAR.

that seems to do the trick

and while circling through the functions I saw there was a DRIVE active on that preset.....hence the distortion