not sending midi notes in seq mode??

dtray187 · Post by **dtray187** » Mon Jul 11, 2011 9:09 pm

Hell, Im trying to set up some tracks in logic for the kronos, but it stops sending the midi notes to logic that I play in seq mode. As soon as I switch to program mode , it sends it again.
How do I fix this?

Thanks!

RonF · Post by **RonF** » Mon Jul 11, 2011 11:01 pm

Just a thought....each track in the Seq Mode has a setting to select whether each track sends midi: Int/Ext/Bth (internal, external, or both). Kronos should default to Bth on a new song.....but it "sounds like" your tracks are set to Int. Give it a look!

dtray187 · Post by **dtray187** » Tue Jul 12, 2011 7:05 pm

Its sending fine untill I copy in a program, then it stops sending midi?

X-Trade · Post by **X-Trade** » Tue Jul 12, 2011 8:41 pm

dtray187 wrote:Its sending fine untill I copy in a program, then it stops sending midi?

Does the Track Status default to Int rather than Bth when you Copy From Program?

Shakil · Post by **Shakil** » Tue Jul 12, 2011 9:06 pm

It may be some sysex or MIDI message sent to Logic when you load a program. Disable program changes in MIDI filter. Try this please and let us know.

RonF · Post by **RonF** » Tue Jul 12, 2011 9:14 pm

Well a program in Program mode sends midi data on the Global channel. When you copy a program into Seq mode (which I assume is what you mean....not just copy the program to another program location), then the midi channel is going to default to the channel set in the track you copied the program to. So make sure that the track, in Seq mode, which contains the program you have just copied, has its Midi status set to Bth, and that the midi channel is set to the same as your Global Channel (in Global/Midi).