Korg Forums

Hello, I have just purchased a Korg Montribe and I love it. I have been playing with the beast for a good few hours now using the in-built speaker, as well as listening through the headphone jack.

I have now got to a point where I would like the record the audio into my DAW/listen through my KRK RP5 monitors. The Monotribe does have an output jack and the manual explains how to connect it up:

(page 4. OUTPUT jack
Connect the monotribes OUTPUT jack to the INPUT hack of your mixer or powered monitor speakers. The output signal is monaural, but the jack will accept either monaural phone plugs or stereo phono plugs (unbalanced)

I currently have an Audio Kontrol 1 audio interface which has a MIC/LINE input connecting to my macbook.

Could anyone help me and advise me on any connectors that I may need to get the Montribe to run through my DAW/speakers please?

Much appreciated!

I think you can better use the correct thread for it. This is only for testing and barely watched at.

It's simple: just connect the Monotribe to your Audio Kontrol 1 with a standard audio cable, connect that to your computer's input jack, then use your monitors as computer speakers. You could also go directly out of the Audio Kontrol to your monitors and computer.