Page 1 of 1
Not able to send sequence from logic after 1.5 update!
Posted: Tue Dec 27, 2011 11:07 pm
by keyboardnut
After the upgrade to version 1.5 on the kronos i cannot send a sequence recorded in logic 9.1.6 to the sequencer.
works fine with the triton i am baffled?
Posted: Wed Dec 28, 2011 1:59 am
by Lou
I just did a quick test and recorded a 5 track combi into Logic 9.1.6.
Reset my setting in Kronos and bounced all tracks back into the Kronos. Works as it always has. Are you sure you have all setting correct?
It's very easy to miss just one parameter and it will fail..
Recording from logic
Posted: Wed Dec 28, 2011 7:26 am
by keyboardnut
Thanks for the reply have now realised needed to put all tracks into record mode this is different than before i think!
Re: Recording from logic
Posted: Wed Dec 28, 2011 8:11 am
by Lou
keyboardnut wrote:Thanks for the reply have now realised needed to put all tracks into record mode this is different than before i think!
Nope, that's the one set of parameters you must have missed.
Kronos has to be record enabled to accept in coming data in the seq.
Glad you got it.