Page 1 of 1
Error message using new AU plug in Logic
Posted: Wed Oct 10, 2012 4:12 am
by jmchiro1
This is the error message I got from Logic's AU manager:
ERROR: -2147450878 IN CALL Remove Property Listener
* * FAIL
--------------------------------------------------
AU VALIDATION FAILED: CORRECT THE ERRORS ABOVE.
--------------------------------------------------
validation result: failed validation
any ideas what might be wrong? Thank you!
Posted: Wed Oct 10, 2012 4:36 am
by Lou
Open Logic in 32-bit mode…
Posted: Wed Oct 10, 2012 1:27 pm
by jmchiro
Yes, I did open Logic in 32 bit mode, and could not get the AU plug in to validate.
Posted: Wed Oct 10, 2012 2:29 pm
by midiman
What OS version are you using?
Posted: Wed Oct 10, 2012 4:38 pm
by jmchiro
Kronos 2.0.2 Mac OS 10.7 So, I think I am up to date. Thanks.
Posted: Wed Oct 10, 2012 4:42 pm
by midiman
10.7.?
There was an issue with 10.7.5 where many AU plugins did not pass validation. This was resolved with 10.7.5 supplemental update -
http://support.apple.com/kb/DL1599
Posted: Thu Oct 11, 2012 3:40 am
by SoundQuest
See the "Kronos Editor 2.0 - Feedbacks" thread for more information
Posted: Thu Oct 11, 2012 8:31 pm
by midiman
jmchiro,
have you found a resolution? I just tested the Kronos plugin in 10.7.5 with the supplemental update I linked above applied, and it validated fine, where it previously had failed validation.
Posted: Thu Oct 11, 2012 8:58 pm
by jmchiro1
Problem resolved!
Yes, your suggestion to use the 10.7.5 supplemental update did the trick! I can use the AU plug in feature in Logic.
Thank you VERY much!
Posted: Thu Oct 11, 2012 8:59 pm
by midiman
Glad it's working for you!
