Page 1 of 1

Self test diagnosis

Posted: Wed Dec 05, 2012 2:15 pm
by Syntey
Hello, I'm going to buy this synth..I heard about self test on Tritons. Do you know that this test exists also on Karma ?

Thank you in advance :)

Posted: Fri Dec 07, 2012 8:33 am
by RobsonLuis
(extracted from Service Manual):

How to start and operate the test mode

How to start:
ENTER + 5 + POWER ON : Full test
ENTER + 2 + POWER ON : All but internal test
ENTER + 3 + POWER ON : EXB-MOSS test (internal test + MOSS DSP1 ~ 6 waveform confirmed)

How to operate:
ENTER : Proceed to the next test
VALUE ^ : Item up
VALUE v : Item down
FF>> : Step up
<<REW : Step down

Notes when the test mode is started:
- When the test mode is started, the calibration value of the joystick is
cleared. So please execute this test item by all means.
- When any of the internal test items is indicated in the LCD,
the contrast of the LCD can be adjusted by turning the Rotary encoder.
However, it sometimes cannot be indicated while the internal test being executed because the data process does not catch up with the operation.
So if the contrast of the LCD is required, please execute it after the internal test is done.

Posted: Fri Dec 07, 2012 9:23 am
by Syntey
Very thanks. :)