Page 1 of 1
Can't change track of sequencer
Posted: Fri Apr 05, 2013 2:44 pm
by botielus
Help! No pedals attached. Just got used triton. All seems great except can't change tracks. The touch screen, buttons, and dial work for changing patches in prog/comb mode but not for the sequencer???
Posted: Fri Apr 05, 2013 6:51 pm
by X-Trade
Check the pedal polarity in Global mode.
Sometimes it can get stuck thinking a note is being held if the pedal polarity is not set to Korg standard (+ I think) without a pedal plugged in.
Posted: Sat Apr 06, 2013 3:05 am
by botielus
weird!? thanx, I'll give that a try. too weird though!
didn't work
Posted: Sat Apr 06, 2013 4:01 am
by botielus
so now I'm tryin to upgrade to newest software and can't even get that to work?!
I've tried the latest (2.5 or whatever). no luck, then tried the lowest upgrade (from the 1.???? on board). same no luck.
I full format disk on both triton and my pc. then do what the instux say, start with two buttons pushed. then it says insert the flppy. then I get this message:
file not found
plz change to system 1 disk
note: I copied all the files in the upgrade disk one to root of floppy.....