It's been many years since I pulled out my floppies to see what compositions I had recorded with the on-board sequencer. (before I went to recording in Cubase) So I'm pretty rusty. Here is what happens:
--- When I try to select a different track than #1, nothing happens, it just stays on #1.
--- When I play, only what is on MIDI channel 1 is heard (in my case a fingered guitar + pads playing simultaneously as Tracks 1 and 2.
--- When I change the Global MIDI Channel to the channel of the track I want to play in (in this case channel 16 and track 7), I hear it while in Global -- but once I'm back in Sequencer mode, it goes back to playing MIDI channel 1 and the two instruments mentioned above.
What and where do I go to fix this?
Thanks.
HELP - .SNG: Can Only Select and Play/Record on Track 1
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
Soniclight
- Posts: 17
- Joined: Thu Dec 06, 2007 5:48 pm
- Location: Woodland Hills, California USA
HELP - .SNG: Can Only Select and Play/Record on Track 1
"Art is contemplation of the world in a state of grace." ~ Hermann Hesse
-
Soniclight
- Posts: 17
- Joined: Thu Dec 06, 2007 5:48 pm
- Location: Woodland Hills, California USA
PS: This happens also with reboot and empty sequencer (just "New Song", nothing else). AND... I installed the original factory Trinity OS 2.4.1 with sample songs, same thing. Can't select tracks -- stuck on track 1. Is this a hardware problem?
Oh, and to make sure that there are no dead pixels, I re-calibrated the screen and enabled "Beep". It beeps on those parameters (track and MIDI tracks) but still does nuttin'...
Oh, and to make sure that there are no dead pixels, I re-calibrated the screen and enabled "Beep". It beeps on those parameters (track and MIDI tracks) but still does nuttin'...
"Art is contemplation of the world in a state of grace." ~ Hermann Hesse