Korg Forums

Hello forums,

When I am at the boot screen where it says 'Loading Factory Resources' and the bar that apparently is supposed to show itloading- doesn't move. It stays at zero while it actually does load and then once its done it just goes to the main screen.


Basically what I am trying to ask is why isn't the loading bar showing its progress and should I be worried? I just got the keyboard last week and has been the same way ever since.

Thanks!

Hi saharfayez

should I be worried?

No. All is fine. Mine is the same.
You will find that should the internal battery expire then you'll see the progress bar in action and load time will take a lot longer.

Cheers

Pete

Pete,

Now that is very good information to know about the battery effects on loading time.

Bill G

saharfayez wrote: loading bar showing its progress and should I be worried? I just got the keyboard last week and has been the same way ever since.

- When Pa3X does not include custom samples , loading bar shows the exact progress of factory data loading !
- When custom samples are loading , especially when preserved in Ram 'cause of ST-BY battery , then loading bar
can't be updated since there is no ram reference to loading progress function ,so you see no progression at all !
- Also when booting after initial custom set loading (not yet preserved in Ram), you will notice that
loading progress bar will be accurate while loading factory data , up to point that custom samples will start
loading , after that point , progression bar will not be updated until entering "style play" interface.

Hope this helps