Korg Forums

Hi there,
ive spent ages with getting volca-recordings synced in daw.
What ive done so far: measuring system-latency (170 samples),
movin recording delay until 1.1 in volca sequencer is 1.1 in recorded audiofile.

Additionally i removed installed driver and replace with one know havin no latency-probs (see here
http://www.native-instruments.com/forum ... -Kontrol-1.

I takes me more than 3 days to fiddling all that s**t out.
Now, finally, i recorded from Volca-beats.
Kick on single channel, Snare on single and so on. It sounds off!



And in same Document with same settings i recorded all Volca-channels on one channel on Logic
and this one is shifted against the other single channels ive recorded before.
And i did phase shifting on complete track to prove:



Im absolutly out off it and there no idea what to do.
Heeeeelp, plz

Nobody with a idea here?

You need to specify precisely how you have your Volcas connected and synced up to your PC. That will determine if it is a problem with how you have them set up, or if it is a computer issue.

Soundcard is Audio Kontrol 1 connected with usb to my mac.
From Kontrol1 Midi-Clock via Midi out to Volca Beats.
Audio output from Volca zu Soundcard Input 1 & 2 via split cable.
Sound is sequenced on volca, not mac.

Hope that helps to find a solution.

Later that weekend i will check what happens if
volca sequencer is empty and midi-signals are going out from mac over soundcard into volca.