Page 1 of 1
Volume is very low for a new style.
Posted: Mon Mar 10, 2014 1:37 am
by quyduy
I just loaded a new style into my Pa3x, the overall sound is two low compare with factory style, I know that we can turn the volume higher or raise drum, bass in vol control but it is still not good enough, anyone know how to fix this.
Thanks
QD
Posted: Mon Mar 10, 2014 2:01 am
by fResH_
go into style record and increase the volym from there if u didnt already, and save it.
Posted: Mon Mar 10, 2014 12:23 pm
by quyduy
Thank a lots
Re: Volume is very low for a new style.
Posted: Mon Mar 10, 2014 12:55 pm
by congan2
quyduy wrote:I just loaded a new style into my Pa3x, the overall sound is two low compare with factory style, I know that we can turn the volume higher or raise drum, bass in vol control but it is still not good enough, anyone know how to fix this.
Thanks
QD
Go to Style Record, Style Edit, adjust the Velocity for each track of each Var, Intro...Ending....
Re: Volume is very low for a new style.
Posted: Mon Mar 10, 2014 6:58 pm
by Sam CA
quyduy wrote:I just loaded a new style into my Pa3x, the overall sound is two low compare with factory style, I know that we can turn the volume higher or raise drum, bass in vol control but it is still not good enough, anyone know how to fix this.
Thanks
QD
It could be a combination of multiple factors: (Velocity-Volume-Expression...). In fact for the best realistic results you should always work with these options and not just push the velocities up for everything to get louder results.
You need to check all these for all elements within a style to make sure everything is where it's suppose to be.
Posted: Sat Mar 15, 2014 2:06 pm
by galettouille
In "Style record" mode push MENU button, then "Style Element Tracks Controls", then "Sound Expr." Tab, and, at last, increase "Expression" values.
Now, save the style.
Posted: Sun Mar 16, 2014 11:14 pm
by quyduy
Many thanks.