Page 1 of 1
how to un mute korg pa800
Posted: Wed Apr 30, 2014 12:34 am
by Maximus1
could someone please tell me how to un mute my pa800? It turns on, looks like everything is ok, however, there is no sound coming out. I tried the head phone jack, factory reseted. I took it to Long and Mccuade, the gentleman there hooked it up to external mixer, there was sound.
I think my son may have pushed button or something that muted the keyboard. i would appreciate any help.
Thank you
Re: how to un mute korg pa800
Posted: Wed Apr 30, 2014 7:04 am
by Thoraldus
Maximus1 wrote:could someone please tell me how to un mute my pa800? It turns on, looks like everything is ok, however, there is no sound coming out. I tried the head phone jack, factory reseted. I took it to Long and Mccuade, the gentleman there hooked it up to external mixer, there was sound.
I think my son may have pushed button or something that muted the keyboard. i would appreciate any help.
Thank you
GLOBAL MODE > AUDIO SETUP > MET/MP3/SPEAKERS ... Make sure speakers are not turned off there.
Posted: Thu May 01, 2014 12:17 am
by Maximus1
Thank you Sir for the info, i tried, however, didn't work.
Posted: Sun May 04, 2014 9:23 am
by AntonySharmman
Maximus1
I'm afraid that your Power amplifier module is defective , that board has built in the headphones module too.
Therefore if all outputs are enabled , PA is on , and only outputs provide audio then you must visit repair center !
Maybe it's a simple PA board fuse but it's better not to mess with disassembling this !
Posted: Sun May 04, 2014 7:39 pm
by MrVlad
to add to what Thordaldus said, can you check that in Global Mode > Audio Setup > Style Kbd Tab that each element is set to Left+Right. if any element is set to Output 1 or Output 2 you won't hear anything of speakers.
Just a thought.
Posted: Tue May 06, 2014 2:36 am
by Maximus1
AntonySharmman wrote:Maximus1
I'm afraid that your Power amplifier module is defective , that board has built in the headphones module too.
Therefore if all outputs are enabled , PA is on , and only outputs provide audio then you must visit repair center !
Maybe it's a simple PA board fuse but it's better not to mess with disassembling this !
I highly appreciated the info and advise, i will take it to a repair shop.
Thank you again.
Posted: Tue May 06, 2014 2:38 am
by Maximus1
MrVlad wrote:to add to what Thordaldus said, can you check that in Global Mode > Audio Setup > Style Kbd Tab that each element is set to Left+Right. if any element is set to Output 1 or Output 2 you won't hear anything of speakers.
Just a thought.
Thank you very much for the suggestion, i checked, everything was sitting on left+right.
thank you again.