Page 1 of 1
change banks
Posted: Thu Jan 15, 2015 8:08 pm
by jonoddie
Hello,
I'm being an idiot.
The micro sampler says that it can hold 8 banks right?
Planning on using it to trigger samples live but i cant seem to work out how to switch between the banks on it??
How do i do that??
Lots of love
xxx
Posted: Thu Jan 15, 2015 10:33 pm
by electrochrisso
From when the MS has just been switched on and ready, Press the Edit button twice, then move the bottom dial next to the Edit button to select the bank, then press the Enter/Shift button twice, I hope I got this correct as I don't have MS in front of me at the moment. You can find the procedure in the manual on page 15, if you do not have the paper one you can download it from the Korg website.
It can get a bit confusing the way you have to select the parameters with the dials and buttons, just something you will have to get used to.
Also if you have a clean MS, I don't think their will be anything on the other banks, so you will not be able to hear anything until you do a bit of sampling.
Have fun.
Posted: Fri Jan 16, 2015 11:56 am
by jonoddie
You massive legend!!
Thank you so much pal!
All the best x
Posted: Sat Jan 17, 2015 3:44 am
by electrochrisso
Your welcome, glad it helped.
Posted: Mon Jan 19, 2015 9:59 am
by jonoddie
Sorry but I've had one last mare. I've loaded the
Samples onto the korg and all is well (I know how
To change banks!!) but now I want to change something
but I don't know how.
If the samples are already on the keyboard how do I edit
Them so some play the whole way through when you hit the key
once (briefly) and some only play only when the key is down and
the sample ends when you're finger is off. How does this work??
All the best
Jon x
Posted: Thu Jan 22, 2015 10:48 pm
by electrochrisso
Look at page 27 in the manual: Loop Playback
Also page 29: Decay and Release