Korg Forums

Posted: **Tue Mar 10, 2015 5:47 pm**

Has anyone figure out a way to use both the mic input and the line in input at the same time on a KP3+?

Posted: **Tue Mar 10, 2015 6:12 pm**

I don't think you can.

Posted: **Tue Mar 10, 2015 7:01 pm**

Posted: **Wed Mar 11, 2015 1:12 pm**

The best workaround would be to sample the incoming line signal, then switch over to the mic (assuming that goes with your setup/music flow )

Posted: **Wed Mar 11, 2015 1:39 pm**

Yeah, it wouldn't as much. The sampling time on the KP isn't long enough to record all the various things going on.

Posted: **Sun Mar 15, 2015 11:08 am**

2 possible ways:
1) Easy way: use external mixer with MIC.
2) DIY hardware mod: Use the schematic and remove the Mic/Line switch, as Mic is mono.
If directly linked to stereo Line-in will make all mono, so add two 1k Ohm resistor or stereo potmeter 50k Ohm in both MIC mono L/R lines to stereo Line-in. So stereo Line will stay stereo but because the passive resistor mono mixing will cause Line L/R crosstalk and stereo stage will be smaller.
Only by adding an active stereo opamp to MIC out will separate the mono L/R into stereo-mono L/R output to the Line L/R will eliminate crosstalk.

http://elektrotanya.com/korg_kp3_sm_ver ... nload.html

http://sound.westhost.com/articles/audio-mixing.htm

Korg Forums

Using 2 inputs on the KP3+

Using 2 inputs on the KP3+