Korg Forums

I've been playing around with tempo matched input routing through the Electribe's Audio In port. I've got Audio In Thru set to off, because I want to use the Electribe's processing on this track. I'm only working within 1 Pattern.

In the Sequencer, I've set every step to trigger and have set each Gate to TIE.

This works fine, though the audio decay's at the tail end of every second bar. How do I get around this?

I'd like to have the external audio always on and still have it processed.

Any insights?

Instead of setting all the steps manually to tie, what I do is press Rec once to put the electribe in arm state, then press and whole the trigger button for that part. This will start the sequencer recording exactly at the beginning of the pattern, just keep holding down the trigger button until the pattern loops. The Ties are created automatically, and you know the duration is then set for the whole pattern.

Much easier and faster.

Thanks, I'll try that.

Tarekith wrote:Instead of setting all the steps manually to tie, what I do is press Rec once to put the electribe in arm state, then press and whole the trigger button for that part.

Actually, this still doesn't seem to work for me.

Either way I do it, I'm still subject to the settings of the Amp/EG section, which doesn't allow a HOLD. I could work around this but I hear a click everytime the envelope resets.

death_club wrote:

Tarekith wrote:Instead of setting all the steps manually to tie, what I do is press Rec once to put the electribe in arm state, then press and whole the trigger button for that part.

Actually, this still doesn't seem to work for me.

Either way I do it, I'm still subject to the settings of the Amp/EG section, which doesn't allow a HOLD. I could work around this but I hear a click everytime the envelope resets.

Try it with the Amp/EG off for the audio in part.