Page 1 of 1

Resetting microKORG original sounds

Posted: Wed Jul 01, 2015 11:15 pm
by WEAREALLJAMESCAMERON
Hello,

I updated and overwrote all the original microKORG sounds about a year ago when I discovered the new presets that Korg released.

I enjoy them all very much but was hoping to switch back to the original factory sounds but can't quite seem to figure out to do it. I tried resetting everything but that just reset all the modifications I did to the patches.

Is there a microKORG SoundEditor Document that has all the original sounds?

Thanks

Posted: Thu Jul 02, 2015 12:32 am
by JohnS
Press Shift-7

Turn knob 1 until it says 'PrG'

Press 7

If it fails, make sure write-protect is off (Use shift-8 for that)