Page 1 of 1
ESX-1 won't sit flat
Posted: Fri Jul 10, 2015 4:28 pm
by reedster
I just received an ESX-1 in the mail and it doesn't quite sit flat on my desk. Rather the bottom left corner is lifted up about a half inch. Anyone know of an easy fix/solution to this?
Posted: Fri Jul 10, 2015 8:35 pm
by tim from texas
mine did this too.. i used two pennies stacked on top of each other.
#gamechanger
Posted: Sat Jul 11, 2015 9:37 am
by Hugo
Mine as well. Just put some folded paper under the relevant pad.
Posted: Sat Jul 11, 2015 10:02 am
by dutchcow
Two pretty easy fixes. A less easy fix would be to make your own case from plywood or print one on one of these fancy 3d printers.
Posted: Sat Jul 11, 2015 4:39 pm
by reedster
Good to know I'm not the only one. Thanks all.
Posted: Mon Jul 13, 2015 2:35 am
by blackmental
I have bought two units as well, brand new, and none of them sit flat.