Korg Forums

Now Kronos is connected but the korg driver setup utility
is popping every 10 min prompting to install, it's installed already !

I had a similar problem. Check out link below to Pa4x forum. Hope it helps.

http://www.korgforums.com/forum/phpBB2/viewtopic.php?t=120192

Ron Thank you man you're amazing Cool

I had a similar problem. Check out link below to Pa4x forum. Hope it helps.

http://www.korgforums.com/forum/phpBB2/viewtopic.php?t=120192

Thank you Ron I’ll try it.

Hi, after windows 10 update my kronos stopped showing in cubase I re-installed the midi driver but the same problem, when I tried to un install the USB driver through ( Korg software it's not showing ...

Hi, some parameters in combi mode are not responding.
I reset the keyboard ( Turn on while holding 0+Enter ). Still the same problem. Any ideas?

Parameters not responding ( midi Chanels, zones, st ...

The plastic degrades over time and is a known problem and I don’t think it can be cleaned off.
The only bit you really need to touch is the area below the joystick. I have put some black tape on this ...

Hey guys,
what's the best way to clean the keyboard plastic ( joy stick area ) it's very sticky & dirty. I used water and soap, didn't work. it's like melted plastic I can't slide my fingers on i ...

Hi,
I installed new third party sounds on my kronos x, now I changed my mind, I installed factory preload sounds KSC. The factory sounds are there but the old third party patches names didn’t reset. ...

I found one more thing, when assigning all the sounds in the 16 tracks and save the song. Actually, PA is not saving any thing. only if there is actual midi notes recorded in PA. Other than that PA wo ...

I found one more thing, when assigning all the sounds in the 16 tracks and save the song. Actually, PA is not saving any thing. only if there is actual midi notes recorded in PA. Other than that PA wo ...

Ok, let’s start over.
I want to use pa sounds to record midi in cubase. Before connecting to PC. I prepare the tracks in PA3.
In sequencer mode I assigned Drums to the first track.
Saved the s ...

Ok, let’s start over.
I want to use pa sounds to record midi in cubase. Before connecting to PC. I prepare the tracks in PA3.
In sequencer mode I assigned Drums to the first track.
Saved the s ...

Ok, let's start over, I'm kinda lost what you trying to do.
First you said you trying to use Pa3x as source for external sequencer.
Hi, I’m trying to use PA3X as sound source for external sequencer ...

Try to use filters on Pa3x Midi IN Channels.
Filter Prg. Change.
That's should stop changing sounds on Pa3x.
In Global Midi/ General Controls you should have few presets, one of them is External Se ...

Try to use filters on Pa3x Midi IN Channels.
Filter Prg. Change.
That's should stop changing sounds on Pa3x.
In Global Midi/ General Controls you should have few presets, one of them is External Se ...