Korg Forums

The good thing is that the actual keyed, the RH3, is used on loads of different keyboards. Spares for that will not be a problem for a long time.

It took me months to get a driver board for the dis ...

But I found this little (~1 square inch) circuit board connected with 3 thin blue wires hanging loose inside, right by the motherboard. I was trying to figure out what it is. It looked like it had bee ...

Are there any MFX/TFX applied to the bass sound copied from the Program that are missing from the chain direct to 3/4?

Guessing you'll have a couple of slots available if you need to copy those int ...

I always think that if the power goes off, a digital mixer/access points/PA driveracks/moving lights etc will take about the same time to start up. Probably longer, for a PA guy to run and physically ...

Just use the Mac's built-in MIDI driver

If you search for the data sheet for the screen (UMSH-8240MD-8T), there is a reset pin that you or a tech could try.

The problem is happening BEFORE the Korg software gets a chance to load, so a Kr ...

Adam, I appreciate that!

I will look into what it might actually cost to have that delivered and I will let you know. Do you know by chance exactly which parts I need?

You're correct in that eve ...

You can't really go direct in with a mic without some kind of pre amp.
Otherwise it sounds all sizzle and no steak.

Hope that helps.

Hooch
\that is COMPLETELY wrong sir! i go direct and ge ...

If you're offering, I'll take the support for sure:

I'm missing the following keys: A1, G2, A3, A#3, F3, B6, C6, C#6, D6, E6.

The entire assemblies are gone though and it's not clear how they'r ...

Hey, all.

Do any of the learned folk here know much about the MIDI spec for the Korg i3 (recent model)? Lovely little thing! Sounds fine and paid for itself in about 20 minutes.

Got a gig I need ...

That reminds me! I must try and find a 4U rack enclosure (locally, that doesn’t cost a fortune) to build my Kronos rack. Its an old K2 73 that currently works as a pile of circuit boards on my worktop ...

Because the app will use SysEx and CC#s to communicate. Obviously there can be no set MIDI commands to trim a sample or load from a storage drive, for example. This is OS level stuff.

The drop down menu in Combi mode will say ‘Copy from Program’. Use this. It will bring all the FX associated with it (if you tick the right boxes 😉 )

As you add more Programs into your Comb ...

I just replaced my old Triton Extreme’s keyboard from an old SY77 and there were trimmer pots on the aftertouch board I had to adjust... Take it there’s nothing similar on the Kronos...

Dug my iConnect4+ the other day to run a very old Roland MIDI controller in to Logic. Many, many routing options on there. 2x dedicated iOS I/Os plus normal MIDI, Ethernet, and normal USB connections. ...