View previous topic :: View next topic |
Author |
Message |
peterbee100
Joined: 30 Dec 2007 Posts: 2
|
Posted: Sun Dec 30, 2007 3:11 pm Post subject: Track Select not working in Sequencer mode? |
|
|
Hi,
My Triton Extreme has suddenly developed a strange problem - I cannot change the 'track select' number in sequencer page P0. Also I cannot change the Midi Channel or Status in sequencer page P2 (Track parameters)
I have disconnected from the PC and am running the Extreme standalone with no Midi or USB connections. I have tried loading the demo songs and cannot change the selected track from track 1. If I create a new song I cannot record on any track except track 1.
All other parameters can be changed normally, except these ones. So I know it is not a hardware fault with the screen or buttons or value slider. I have tried a factory reset and also tried re-installing the firmware to 1.05 so am now at a bit of a loss...
Would be grateful for any suggestions....thanks |
|
Back to top |
|
|
Sharp Site Admin
Joined: 02 Jan 2002 Posts: 18197 Location: Ireland
|
|
Back to top |
|
|
peterbee100
Joined: 30 Dec 2007 Posts: 2
|
Posted: Sun Dec 30, 2007 4:13 pm Post subject: |
|
|
Spot on! Thanks a lot Sharp. |
|
Back to top |
|
|
Gargamel314 Platinum Member
Joined: 25 Dec 2007 Posts: 1147 Location: Carneys Point, NJ
|
Posted: Tue Jan 01, 2008 9:45 am Post subject: |
|
|
I've often had this problem and found out that it's some controller still active - like my pedal which isnt set for the correct polarity, and its still sustaining. If this happens again try unplugging your damper pedal. |
|
Back to top |
|
|
|