|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
afshin2003
Joined: 17 Sep 2016 Posts: 3
|
Posted: Wed Jun 21, 2017 9:36 am Post subject: DS-DAC-10R as a live recorder |
|
|
Hi Folks,
It's been about a year I'm playing with DS-DAC-10R as a generic DAC. Now I'm going to record my daughter's live piano performance. I'm not sure if what kind of microphone I need or is it possible to connect mic's output to my DAC's lines?
Appreciate all comments,
Afshin |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3796
|
Posted: Wed Jun 21, 2017 10:31 pm Post subject: |
|
|
The DS-DAC-10R input sensitivity in phono input setting is nominally 5mV RMS, with a maximum input level of 100mV RMS, so is well suited to use with microphones. Stereo microphony is recommmended to get the best realism for recording piano and to make the most of the dynamic range of the DS-DAC-10R. Something like the Rode NT4 microphone might be worth considering, since it has a reasonably low noise floor, equivalent to 16dBA (a quiet room being 30dBA, and a broadcast studio being typically 20dBA). The NT4 output is given as 12mV RMS at 94dBA, so well clear of the maximum, even for recording very loud sounds. Neither of the two output leads supplied with the NT4 has RCA jacks suitable for the inputs on the interface, so some form of adapter and cables will be necessary e.g. a 1/8" stereo jack to RCA adapter plus two RCA to RCA cables.
There are many cheaper microphones out there if you just want to suck it and see, but quality generally follows cost, unsurprisingly.
. |
|
Back to top |
|
|
afshin2003
Joined: 17 Sep 2016 Posts: 3
|
Posted: Sat Jun 24, 2017 12:12 pm Post subject: |
|
|
Hi Voip,
many thanks for the detailed response. I'll go for a NT4!
Best,
Afshin |
|
Back to top |
|
|
afshin2003
Joined: 17 Sep 2016 Posts: 3
|
Posted: Sat Jun 24, 2017 1:17 pm Post subject: |
|
|
Voip,
Considering input sensitivity, I'm using a Yamaha AS-2100 amp. Its phono input sensitivities are 2.5 mVrms on MM and 100 uVrms on MC. What do you think using Yamaha's phono stage amplifier to connect NT4 and using REC OUT to connect to DS-DAC-10R ? I guess its RIAA equalizer is not suitable for mics. Isn't it?
Best,
Afshin |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3796
|
Posted: Sat Jun 24, 2017 4:30 pm Post subject: |
|
|
The RIAA equalisation will make the microphone audio very bassy with much reduced high end. Also, the microphone will overload the phono input quite easily, so not recommended.
. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|