|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
demuxe
Joined: 15 Jul 2017 Posts: 14
|
Posted: Sat Aug 05, 2017 11:59 am Post subject: Sequencer -> Electribe ESX. MIDI Control Change & FX |
|
|
I have an Electribe ESX-1 SD. For various reasons I currently need to use an old, simple sequencer software called SEQ24.
I want to sequence changes in the FX settings of the ESX-1 parts. It seems I managed to do it, but I'm still a bit confused.
I've assigned 3 different MIDI channels to Drum Part, Keyboard Part 1 and Keyboard Part 2.
I managed to sequence FX on the Keyboard Part 1 by sending Control Change data (*) over the MIDI channel belonging to that part.
But apparently, this only works if I send Control Change data to Keyboard Part 1. If I send the same data over the MIDI channels for Keyboard Part 2 or Drum Part (of course after enabling the same effect for those parts), no change in the effect parameters happens anymore.
Does this make sense to you? Is it by design? Am I doing something wrong?
(*) Example: I set the Keyboard Part 1 MIDI channel to 7, and then I send over MIDI channel 7
-a Control Change 12 with value 56 which sets the Ring Mod FX
-a Control Change 92 to set its Oscillator Frequence parameter
-a Control Change 93 to set the Balance parameter (these Control Change numbers come from the ESX MIDI Implementation).
This enables Ring Mod for Keyboard Part 1 with a specific combination of parameters. Then I send more Control Change 92 and 93 data, which change further the effect settings. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|