|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
ilwoody
Joined: 06 Mar 2019 Posts: 2
|
Posted: Wed Mar 06, 2019 12:29 pm Post subject: NanoKontrol 2 volume is actually a pitch bend |
|
|
Hello, I just bought and configure the nanoKontrol2 with Cubase 9.5 Artist
It works fine a part from the volume button that does not trigger the mixer volume of a specific track, but the pitch bend.
How do I swicth so that it can control the volume?
Thank you |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3777
|
Posted: Wed Mar 06, 2019 9:30 pm Post subject: |
|
|
Was the nanoKONTROL2 connected to the USB port whilst the SET MARKER and REW buttons were pressed, and has it been set up as Mackie Control in the Device Settings, and NanoKONTROL2 for MIDI In/Out ports? |
|
Back to top |
|
|
ilwoody
Joined: 06 Mar 2019 Posts: 2
|
Posted: Sat Mar 09, 2019 11:57 am Post subject: |
|
|
voip wrote: | Was the nanoKONTROL2 connected to the USB port whilst the SET MARKER and REW buttons were pressed, and has it been set up as Mackie Control in the Device Settings, and NanoKONTROL2 for MIDI In/Out ports? |
Yes sir I did all of that. Actually I saw no messages or alert when I plugged the controller while pressing the buttons, so I cannot really say I was pressing properly, but I mean... How many way there could've been.
If I'll try again, should I reset any feautures, like disable mackie control or anything else?
Thanks for helping. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|