Pa 4X main board fault

Georgeymc · Post by **Georgeymc** » Sun May 05, 2019 1:21 pm

Hi All, I'm having an issue with my Pa 4x......I used it Thursday without issue at a wedding ceremony and then Sat went to use it and I have an unusable low audio output. When i say unusable I mean to say its there and I can hear it with headphones but its not hot enough for it to work with a PA. I've just installed the new Next os and nothing has changed. Any insights and help would be greatly appreciated. Philip

karmathanever · Post by **karmathanever** » Sun May 05, 2019 3:14 pm

Hey Philip

Do you get the same low audio from the headphones?

Pete

Georgeymc · Post by **Georgeymc** » Sun May 05, 2019 6:22 pm

karmathanever wrote:Hey Philip

Do you get the same low audio from the headphones?

Pete

Yeah....so low that it’s barely audible over the noise of the keys, but it is there and all functions are operating correctly

seaside · Post by **seaside** » Sun May 05, 2019 6:29 pm

Is the MAXX master EQ turned on with VOL +2 ? Terry

Georgeymc · Post by **Georgeymc** » Sun May 05, 2019 6:52 pm

I’ll check that now Terry thanks

Georgeymc · Post by **Georgeymc** » Sun May 05, 2019 6:57 pm

seaside wrote:Is the MAXX master EQ turned on with VOL +2 ? Terry

Yes it’s on and set at 2.0. When I play a note the “out” level indicator hits approx 25

Georgeymc · Post by **Georgeymc** » Fri May 17, 2019 1:51 pm

update.....the problem was hardware, a local engineer had to remove 3 chips from the main board individually before he found the culprit. FYI P

Asena · Post by **Asena** » Fri May 17, 2019 2:26 pm

I hope it,s ok Now, Thats realy bad, but it,s Electical stuf and can happen some times, God luck.