|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
pax-eterna.1 Senior Member
Joined: 03 May 2017 Posts: 393
|
Posted: Thu Aug 25, 2022 4:10 pm Post subject: Photo needed of Radias EXB cable |
|
|
I've acquired a used M3 61 with the Radias board but no cable - they are not available anymore but I can make one, I just need a photo of both connectors on the cable itself.
Seems the header on the EXB board my be a bespoke one...
Can anyone help out? |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3784
|
Posted: Thu Aug 25, 2022 8:41 pm Post subject: |
|
|
The images in the link below might help a bit.
https://reverb.com/item/52083814-korg-exb-radias-expansion-klm-2027-m3-mmt-synthesis-24-voice-vocoder-radias-incl-mounting-screws
The cable seems straightforward enough. Measure the connector pin spacing on the board as accurately as possible, and also the connector on the M3 itself. Find the pin 1 reference on the silk screen printed on the EXB-Radias PCB and also the M3 connector.
The connector on the M3 is a Samtec part, STMM-110-02-G-D-SM-K-TR, which is 2.0mm pin spacing, so look for the mating IDC (insulation displacement connector). Check that the connector on the EXB-Radias is the same. The ribbon cable will need to be 1.0mm spacing.
. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|