View previous topic :: View next topic |
Author |
Message |
Sterling Holobyte
Joined: 19 Jun 2008 Posts: 7 Location: Wisconsin
|
Posted: Thu Jun 19, 2008 9:09 pm Post subject: Changing Track Volume - 01/WFD |
|
|
Hi all,
How do you change the volume of a specific track in the sequencer?
I haven't been using my Korg 01/WFD much(Bad I know, I am trying to rectify that) and I remember being able to easily change the volume of a track while working on a song, but I can't for the life of me remember how I used to do that.
I've checked the internet and looked in the manual. Though for me looking through the manual is no good as I don't have a PH.D in electronic terminology. And I didn't find anything about it on the internet, except, hopefully, here.
Any help would be most appreciated! |
|
Back to top |
|
|
dave Senior Member
Joined: 01 Jun 2002 Posts: 402 Location: Dublin, Ireland
|
Posted: Fri Jun 20, 2008 12:59 am Post subject: |
|
|
Go into the Event Editor for the track and insert a Control Change event (or a series of them for a crescendo or diminuendo) for CC7 ranging from 1 (almost inaudible) to 127 (full volume).
Kind regards. _________________ Dave Bourke
- ideation - |
|
Back to top |
|
|
Sterling Holobyte
Joined: 19 Jun 2008 Posts: 7 Location: Wisconsin
|
Posted: Thu Aug 28, 2008 8:50 pm Post subject: |
|
|
Thanks Dave for your reply. Though doing it that way would take forever as I needed to change the sound on the track for the whole song.
I did find out how to do it: You know where it says Edit:PRG in the lower section right on the main display? Well, all I needed to do was click on that and change it to Edit:VOL.
I KNEW there was an easy way to do that.
Thought I would post my findings in case someone else needs the same advice that I did. |
|
Back to top |
|
|
ellll Platinum Member
Joined: 09 Dec 2004 Posts: 3118 Location: Panama City, FL
|
Posted: Sun Feb 15, 2009 6:14 pm Post subject: |
|
|
Good solid orig. answer...
Thanks, John (ellll) |
|
Back to top |
|
|
|