Hi to all, today modifying some programs in M3's combi with the tone adjust, I tried to figure how it's possible to modify the "nine engine's programs" on a Kronos' combi.
Does it open a special windows with the specific engine's interface or the parameters are shown in the "classic" tone adjust's window?
Thanks.
Max
Nine engines management in a combi
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Hi Max,
I'm not familiar with the M3's tone adjust in combi, but the Kronos is pretty close to the Oasys, so for instance, you can check it online here:
http://www.karma-lab.com/oasys/gui/OASY ... _GUI2.html
Phil
I'm not familiar with the M3's tone adjust in combi, but the Kronos is pretty close to the Oasys, so for instance, you can check it online here:
http://www.karma-lab.com/oasys/gui/OASY ... _GUI2.html
Phil
Thanks for reply, Spiderweb.
checked and looked at Oasys manual and...yes, I think that the tone adjust have the same concept of M3, but my question is: Ok for hd-1 and cx3 engines where you can assign parameter to slider and button like in program mode, but the MS20ex's engine, for example, has a particular interface in program mode, so my question is: when I have to modify an ms20's program in a combi ad I push the tone adjust button, I'll have the same "window" like HD-1 with other parameters, or it opens a new window that allow me to modify the program showing the same interface that I find in MS20ex's environment?
Max
checked and looked at Oasys manual and...yes, I think that the tone adjust have the same concept of M3, but my question is: Ok for hd-1 and cx3 engines where you can assign parameter to slider and button like in program mode, but the MS20ex's engine, for example, has a particular interface in program mode, so my question is: when I have to modify an ms20's program in a combi ad I push the tone adjust button, I'll have the same "window" like HD-1 with other parameters, or it opens a new window that allow me to modify the program showing the same interface that I find in MS20ex's environment?
Max
Hi maxipf,maxipf wrote:Thanks for reply, Spiderweb.
checked and looked at Oasys manual and...yes, I think that the tone adjust have the same concept of M3, but my question is: Ok for hd-1 and cx3 engines where you can assign parameter to slider and button like in program mode, but the MS20ex's engine, for example, has a particular interface in program mode, so my question is: when I have to modify an ms20's program in a combi ad I push the tone adjust button, I'll have the same "window" like HD-1 with other parameters, or it opens a new window that allow me to modify the program showing the same interface that I find in MS20ex's environment?
Max
While in COMBI or SEQ mode, you won't see the graphical representation of the MS-20EX as you do in Program mode. Your editing here will be done on the Tone Adjust page, which looks similar regardless of which engine you're using. In Tone Adjust, you can customize each slider, switch, or knob to perform the function that you want.
If you need the graphical representation (say, to make a patch in MS-20EX), you can temporarily switch to PROG mode, edit, save, then switch right back to SEQ mode.
Richard Formidoni