Korg Forums

Hi guy's, My Oasys is silent on the output if I plug it into a pair of Mackie speakers or anything else. It is only when it is connected to the D3200 via 1/4 that the noise appears. Even if I set up just the Oasys and the D3200 on their own the noise is still there. I talked to my mate who has both ...

Thanx for that mate. To tell the truth I got the D3200 just so I cold remove the PC from the setup altogether. So no, the PC is not connected in any way. However my Yamaha ES7 does not do this at all nor the Kurzweil. In fact none of the large selection of analouge synths I have here do this either ...

Yes. It is only the Oasys that this happens with. To be more clear about this, I would say the noise is more like digital switching noise with a nasty hum over it. Could be simply because the Oasys is like a PC with a keyboard bolted on.

Hi Guy's OK, well thanks to Dan 1.3 is on and working (Thankyou again Dan for that) :) Pulled new ram out, left stock ram in......perfect. The ram i got was matched for make, size, CAS time. In fact the only way you cold tell the two sticks apart was by slot location. So question 1 is: If I wish to ...

I too loaded the official 1.3 into my until now perfect Oasys. I have never had a freeze or a hic cup of any kind on my baby, but now it is unplayable. I have reburnt the iso onto a new disk three times on two different writers and still the problem persists like: 1. locking up for up to a minute ...

I can't see the AL1 doing a great Minimoog emu really, although it should do the OBX OBxa and P5 rev3 quite well as these are not analouge in the same way the minimoog.