Problem with RPPR and Pads

Yarsha · Post by **Yarsha** » Thu Jun 19, 2014 8:11 pm

Hello guys,

i'm sorry, i've tried to find out another similar topic but I didn't.

Can you please help me?

i've assigned RPPR to different notes C7, B6, etc... Each is triggering a different midi channel. In the sequencer mode.

I've assigned the same notes to the pads. Then I've changed the active midi channel to the one that I want to play (while the pads should trigger the backing patterns).

When I press the notes on the keyboard the pattern plays correctly on the correct midi channel.

But when I press them with the pads, the patterns don't start. They just play the note C7 etc... It plays only when the active midi channel is the same as the one that the pattern should play. It was working 1 month ago. Now I'm trying and it doesn't work anymore, I don't know why...

Any ideas?

80salife · Post by **80salife** » Thu Jun 19, 2014 8:48 pm

it should work ^^ Midichannel with right sound in seq Mode, with right pattern, and right botton on trigger pads with right midi-channel.

HardSync · Post by **HardSync** » Fri Jun 20, 2014 10:39 am

It's likely that the pads are set up to play the active track channel (i.e. "TCH"). You can change the MIDI (track) channel the pads will trigger on the Pads screen where you assign the notes. At the top of the columns, next to the pad numbers, are the channels that the pads are assigned to. Select the appropriate MIDI/Track channel for each RPPR pattern/track there.

Yarsha · Post by **Yarsha** » Mon Jun 23, 2014 10:57 pm

thank you guys... i'll try this out

Yarsha · Post by **Yarsha** » Tue Jun 24, 2014 10:31 pm

It's solved.

The problem was actually the opposite: The tracks in the pads HAVE to be set up as Tch. Not as single midi channel.

With that, it works smoothly

Thanks!