Video of the OS being installed.

cloydmello · Post by **cloydmello** » Fri Dec 05, 2014 11:48 pm

Sharp wrote:Hi cloydmello
The firmware improves the reliability of USB MIDI transmissions to USB 3.0 ports on Windows computers.

And the start-up display has been modified to include the logos representing the KRONOS synth engines.

Regards
Sharp.

Thanks mate... Cheers...

Post by **Sharp** » Sat Dec 06, 2014 1:52 am

No bother at all.

Happy to help.

Sharp.

DennyC · Post by **DennyC** » Sun Dec 07, 2014 3:44 am

Here comes a dummy question. Since I need to update to the 6.04 version,
and I did print out the instructions, what exactly do I have to do with the 1.12
usb midi driver? I installed the 1.12 on my computer and also created a folder on my desktop and put the midi driver inside. Will this 1.12 folder automatically help load the software version 6.04 when I follow the instructions in the pdf?

This one has got me stumped! I need a little help from my friends!

Thanks, Denny C

Post by **Sharp** » Sun Dec 07, 2014 11:45 am

Hello.

The Firmware is for your KRONOS, the midi drivers are for your PC only. So when it comes to your KRONOS the only thing you need to do is follow the instructions for installing the firmware on your KRONOS.

Regards
Sharp.

DennyC · Post by **DennyC** » Sun Dec 07, 2014 4:19 pm

Thanks so much. I will give it a try later today!

Denny C

DennyC · Post by **DennyC** » Tue Dec 09, 2014 4:30 am

Thanks again Sharp! Got to it a few minutes ago and I am a happy camper.

Denny C

Dniss · Post by **Dniss** » Wed Dec 10, 2014 8:41 pm

cloydmello wrote:I never realised that was another update...have had that file downloaded for ages...

Me too!

Isn't it like finding a forgotten 20$ in a coat pocket?

Thanks Sharp for the vid.