KP3 not looping

Riklink · Post by **Riklink** » Thu Feb 19, 2015 10:03 am

Hi all,

Not sure if my KP3 is not working correctly. Brought second hand from ebay.

So after recording a sample the unit only plays back while i'm holding down the assigned sample button.
I was expecting it to run on a continuous loop.

Is this not the case?

Thanks for your replies

rammstein · Post by **rammstein** » Fri Feb 20, 2015 5:49 am

you need to complete the loop when sampling. when you stop the sampling before the loop ends, it becomes a one-shot.

Spheric El · Post by **Spheric El** » Fri Feb 20, 2015 3:19 pm

Hi Riklink,
On version 2 there is up to 4 different playback modes.
If your sample is green-it's a loop and has 4,while a oneshot is red and has but 2.
-Go into edit sample mode by holding shift and tapping your sample . You may then have to press your program encoder ,before selection with same encoder.Different modes for loop are re-sync start point or not, and toggle on/off variations . One shots can't change start point.

Riklink · Post by **Riklink** » Sat Feb 21, 2015 1:36 am

Great thanks guys
I'll give that a go