Do you get sound from the sub outputs? If so, your tubes may be at fault.theo2nazareth wrote:Hey guys,
It looks like I have the same problem than you : The EMX SD gets on, pattern loaded, but no sound is coming out the phones & main outputs ..
Only some super-low noise in which I can hear my pattern when I turn the Volume to its maximum.
The power block is well plugged and works well : I tested it with another EMX.
Can you help me ?
Help! Electribe working, but no sound~!
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Korg: M3M, EMX2, EMX1 (x2), ESX1, ER1, EA1, R3, MicroKorg, MicroSampler, Micro X, KP2, KP3, KPMini 1&2, KO1&2, KP Pro
Roland: SP808, MC505, Handsonic 10, Fantom X6, RC505, CG8
Emu: Command Station MP7 (x3!), Proteus 2000, Planet Earth, Virtuoso, Planet Phatt, XBoard49
Novation: UltraNova, Nova
Yamaha: RM1X, CS2X, DX11, DX Reface, YC Reface
Other: Zoom R24, Quasimidi 309, Beat Thang, Akai MPC1000 and a couple of Omnichords
Roland: SP808, MC505, Handsonic 10, Fantom X6, RC505, CG8
Emu: Command Station MP7 (x3!), Proteus 2000, Planet Earth, Virtuoso, Planet Phatt, XBoard49
Novation: UltraNova, Nova
Yamaha: RM1X, CS2X, DX11, DX Reface, YC Reface
Other: Zoom R24, Quasimidi 309, Beat Thang, Akai MPC1000 and a couple of Omnichords
NO SOUND COMING OUT OF KORG ELECTRIBE
hi guys ...i had only a hiss coming out the left channel and i ve reseted to the factory settings my electribe esx 1, RELOADED THE DATA AND IT WORKED JUST FINE AFTER THAT..... BUT MAKE SURE YOU SAVE DATA INTO THE MEMORY CARD FIRST OR YOU CAN DOWNLOAD IT HERE: https://github.com/skratchdot/open-elec ... r-Download
AFTER YOU ERASED ALL DATA RELOAD IT FROM THE MEMORY CARD HERE S HOW TO DO IT: while machine is off hold down the SOLO/TRANSPOSE and WRITE buttons and TURN IT ON .. IT WILL ASK YOU TO INITIALIZE ALL DATA AND PRESS THE PLAY BUTTON TO ERASE ...
AFTER I TURN IT ON, NO PATTERNS AND SOUND DATA WERE ON THE UNIT,
SO, IN THE GLOBAL MODE I HOLD DOWN THE SHIFT AND ON THE PATTERN KEY 16 TO LOAD DATA FROM THE CARD AND EVERYTHING WAS JUST FINE AFTER ALL.
IT WORKED FOR ME..... HOPE THAT HELPS FOR YOU TOO GUYS ....CHEERS
AFTER YOU ERASED ALL DATA RELOAD IT FROM THE MEMORY CARD HERE S HOW TO DO IT: while machine is off hold down the SOLO/TRANSPOSE and WRITE buttons and TURN IT ON .. IT WILL ASK YOU TO INITIALIZE ALL DATA AND PRESS THE PLAY BUTTON TO ERASE ...
AFTER I TURN IT ON, NO PATTERNS AND SOUND DATA WERE ON THE UNIT,
SO, IN THE GLOBAL MODE I HOLD DOWN THE SHIFT AND ON THE PATTERN KEY 16 TO LOAD DATA FROM THE CARD AND EVERYTHING WAS JUST FINE AFTER ALL.
IT WORKED FOR ME..... HOPE THAT HELPS FOR YOU TOO GUYS ....CHEERS