In this Youtube Video guy uses resonance knob for string vol

[morty]

see video

https://www.youtube.com/watch?v=3tO6RH6bcbI


Combination mode: "Piano & Strings
Does anyone know how to put the string volume on the tone knob to turn up and down volume as shown on this video?

thanx and merry Christ-mas

actually I think it was the velocity control knob.

[Dan Stesco]

Hi !

Is not a resonance. Is a User Knob 2.
Select the A000 Piano & Strings.
Open Page P1 Controllers
In the Realtime Control Knob Assign zone will see the USER[2] are set to Knob Mod 2 (CC#19) by default.

Change the USER[2] to Volume (CC#07)
Check the KNOB 2 now

[morty]

Ill try it tomorrow when I go to church where the Korg is.
I thought I had to do something like that Makes sense

I just hate touching the strings on the screen... if you don't hit it just right it might not sound or solo etc
its better to have a volume control in the user mode

thanks again

[voip]

An expression pedal is another way to do this. The MIDI filters for the Combi need to be set so only the strings get the CC#07 or CC#11 messages that the Krome generates from the pedal input (set in the Global menus). Using CC#11 is preferable.

.

[morty]

Thanks VoIP , but I have 2 pedals going already one sustain another trigger a Roland VK8M organ sound module Leslie simulator so 3 pedals might be too much and it's just the strings only I want volume control over nothing else but good idea thanks

[morty]

Hi !

Is not a resonance. Is a User Knob 2.
Select the A000 Piano & Strings.
Open Page P1 Controllers
In the Realtime Control Knob Assign zone will see the USER[2] are set to Knob Mod 2 (CC#19) by default.

Change the USER[2] to Volume (CC#07)
Check the KNOB 2 now

Thanks Dan.... it worked! one little problem maybe you can help Im not a midi expert

I have my Krome midied into my Nord E5 so when I adjust the strings on the Krome it affects the Nord (so I turned off program change on the Krome)
but then the sustain on the Nord doesn't work.... any midi suggestions to have both working together.

thanx

[Dan Stesco]

Ok.
The Knob transmit the Control Change not Program Change so open the Krome GLOBAL>MIDI and turn off the Enable Control Change. Unfortunately will stop the damper transmit too. So use a different damper pedal for NORD.
All the best,
Dan

[morty]

Thanx Dan yea I'll have to do that.