I was aving a combi and it froze the M3 up.. I waited and and waited and it just said saving ..
i had to turn it off in the end and now it starts to load the red bar goes along a bit and stops about 1/4 of the way accross
the manual trouble shooting says nothing about htis
what the heck do I do this is urgent!!
URGENT!!! Help it wont boot up!
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
shaneblyth
- Senior Member
- Posts: 395
- Joined: Sat Mar 03, 2007 2:21 am
- Location: Queenstown, New Zealand
-
lcmorley
- Senior Member
- Posts: 312
- Joined: Wed Jan 10, 2007 10:53 am
- Location: Cardiff, South Wales, UK.
- Contact:
My first suggestion would be to get in contact with Korg tech support. 
Music is the stuff Dreams are made of!!!
Please checkout my music at www.soundcloud.com/lcmorley
My Gear History (from 11 years old until now):
Yamaha PSR-31, Technics KN1000, Technics KN5000, Technics KN7000, Korg PA-80, Korg Triton Classic, Microkorg, Korg Triton Studio, Alesis Ion, Korg Legacy Collection, Korg Triton Extreme, Roland Juno D, Access Virus TI 2, Korg M3, Korg Oasys, Roland TR-8, Korg Kronos 2 88 Platinum, Mac Studio, Logic Pro, Kontrol S61 MK3, Native Instruments Komplete Ultimate, Diva, Serum too name a few.
Please checkout my music at www.soundcloud.com/lcmorley
My Gear History (from 11 years old until now):
Yamaha PSR-31, Technics KN1000, Technics KN5000, Technics KN7000, Korg PA-80, Korg Triton Classic, Microkorg, Korg Triton Studio, Alesis Ion, Korg Legacy Collection, Korg Triton Extreme, Roland Juno D, Access Virus TI 2, Korg M3, Korg Oasys, Roland TR-8, Korg Kronos 2 88 Platinum, Mac Studio, Logic Pro, Kontrol S61 MK3, Native Instruments Komplete Ultimate, Diva, Serum too name a few.
or try with panic boot procedures if it exists
i am quite sure it is not explained in the manual so i cannot say that it exists or not, but in the trinity it exists (an was not explained in user manual). it requires to press two buttons (i do not remember which ones) while powering up and trinity should reset everything (even if you lose all combi and prog in that case).
for trinity i found the procedures searching forums and sites on the web
good luck
i am quite sure it is not explained in the manual so i cannot say that it exists or not, but in the trinity it exists (an was not explained in user manual). it requires to press two buttons (i do not remember which ones) while powering up and trinity should reset everything (even if you lose all combi and prog in that case).
for trinity i found the procedures searching forums and sites on the web
good luck