Korg Forums

Hello,
I have a problem (big surprise) that i think a lot of u might experience.
here it is;
when i bring in a Synth (or other instrument but many a synth) and I put on both or just one of the SW switches and i record it for the song. than i go to another track and record that track but when i do the synth is all messed up. so than i have to go to that track and re-put on the switches! i have to do this every time! It gets pretty frustrating cause it never stays on!!!
Any ideas? is this normal? or do I have a problem with my O?
Thanx


Pura Vida
DJ

Nobody?
Oh well. So nobody has experienced this? i guess im on my own!
But no worries! I'll manage! Somehow.... or...maybe i wont....lol



Pura Vida
DJ

Ultimate Dj wrote:Nobody?
Oh well. So nobody has experienced this? i guess im on my own!
But no worries! I'll manage! Somehow.... or...maybe i wont....lol

Pura Vida
DJ

I'm not at home right now, so unfortunately I can't check this out. I'd suggest calling your Korg Distributor's product support department; I'll bet that they'd be able to help.

Best regards,

Dan

Try turning the switches on after you've started recording. My sequences usually have a one measure dead time where everything is set up such as that. It should work on the OASYS!

ryan42 wrote:Try turning the switches on after you've started recording. My sequences usually have a one measure dead time where everything is set up such as that. It should work on the OASYS!

yes, this is the answer - record/capture those controller values into your sequence - you can record them live like Ryan sugests, or enter them from the Event Edit List.

Regards,

Jerry

Thnx alot guys!
u rok! I can't wait to try this! if it works it'll really help me out!
thnx again!


Pura Vida
DJ