Problem sending program changes between SONAR 7 and Oasys88

pilar5810 · Post by **pilar5810** » Thu Feb 28, 2008 12:04 pm

Hi all,

I am hooking up my Oasys (running 1.3.1) to SONAR 7 Producer Edition and while I can get combi changes to work, I can't get program changes to work.

In addition, I get audio when I'm in combi mode, but no audio when I'm in Program mode, unless I turn "Local Control" on in the Oasys. In that mode, of course, it's completely ignoring Sonar, as it should.

So what am I doing wrong? Is it my instrument definition? Should I use one .INS file for combis? And a separate .INS file for progs? (the actual titles of the patches come up in both modes, so I thought my instrument defs were fine.)

I've reserved midi channels 1-10 for combi's and 11-16 for progs.

The Oasys is set up to receive combi changes AND program changes. At this point I'm stumped and need expert advice from you. Thanks!

pilar5810 · Post by **pilar5810** » Thu Feb 28, 2008 12:57 pm

I should have also mentioned that I do get prog sounds and changes in SEQ mode, just not in PROG mode.