Korg Forums

Hi,

can somebody help me with this (a problem also for other live-players?) :

When playing a combination live I send to the FOH console 2 stereo pairs, one pair main L/R for the usual sounds, and a second pair L/R for solo sounds to make it more comfortable for the tech to mix it. The solo sounds I send out on individual outs 1/2 of my OASYS, but the MFX and TFX are only related to the main L/R, so I have to reprogram the ifx (which is not really a problem, but it takes time).
Now the question: Is there any easier way, to route the MFX and TFX to the individual outs or do I have to program the ifx to let the sounds sounding like in program mode?
To change the routing in Global Mode is not a solution to me, because depending on the songs, I need the MFX/TFX for the usual sounds on the main L/R an then, when playing solos (and changing the combination with foot pedal) on the individual outs and there is no time to change something in Global Mode in the live situation

Thanks
SoulBe

As far as I am aware, you'll have to use the IFX only for the solo parts which will be routed to ind. outs, while all the rest can make use of the MFX and TFX too.
This probably means that you'll have to do some re-programming to achieve the desired result.
The Ind.out Bus in global page lets you have MFX and TFX on the selected pair of ind. outs, but in this case what comes out is the same Main L/R signal.
You probably already know pag 649 of the operation manual.

That´s what I suspected .
What was this page 649 ? In the parameter guide it´s something about multisamples and the manual ends up at 245 or something ?

Thanks
SoulBe

SoulBe wrote:Hi,

can somebody help me with this (a problem also for other live-players?) :

When playing a combination live I send to the FOH console 2 stereo pairs, one pair main L/R for the usual sounds, and a second pair L/R for solo sounds to make it more comfortable for the tech to mix it. The solo sounds I send out on individual outs 1/2 of my OASYS, but the MFX and TFX are only related to the main L/R, so I have to reprogram the ifx (which is not really a problem, but it takes time).
Now the question: Is there any easier way, to route the MFX and TFX to the individual outs or do I have to program the ifx to let the sounds sounding like in program mode?
To change the routing in Global Mode is not a solution to me, because depending on the songs, I need the MFX/TFX for the usual sounds on the main L/R an then, when playing solos (and changing the combination with foot pedal) on the individual outs and there is no time to change something in Global Mode in the live situation

Thanks
SoulBe

A side note: you probably already know this, but you can copy from MFX and TFX to IFX, which may save a little time. You'd still need to adjust the wet/dry mix.

No I didn´t knew till now, thanks for that hint, I´ll go for it in the manual

SoulBe