In a combi the Timbre Parameter -> Pitch: Bend Range is limited to +-24 semitones even when the engine at the Timbre would allow +-60.
This makes combi programming for the Continuum a bit problematic as I have to change all the programs individually.
Bend Range limitation in Combi
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
sirCombatWombat
- Full Member
- Posts: 236
- Joined: Mon Apr 09, 2007 8:11 am
- Location: Finland
Bend Range limitation in Combi
Samu Teerilahti
Composer, IT Researcher, Blacksmith
Current hardware:
OASYS 88 (EXs1-3, STR-1, LAC-1, MOD-7, EXb-DI), Haken Continuum (½), Alesis A6 Andromeda, Novation Supernova II ProX, Doepfer A-100 BS2, PC, 220lbs Anvil, 3.3lbs Hammer.
Composer, IT Researcher, Blacksmith
Current hardware:
OASYS 88 (EXs1-3, STR-1, LAC-1, MOD-7, EXb-DI), Haken Continuum (½), Alesis A6 Andromeda, Novation Supernova II ProX, Doepfer A-100 BS2, PC, 220lbs Anvil, 3.3lbs Hammer.
-
sirCombatWombat
- Full Member
- Posts: 236
- Joined: Mon Apr 09, 2007 8:11 am
- Location: Finland
Ha, the parameter allows +-24 Bend Range for HD-1 programs too 
And on most programs it does not sound bad at all, which makes me wonder why it has been limited to +12 at program level
And on most programs it does not sound bad at all, which makes me wonder why it has been limited to +12 at program level
Samu Teerilahti
Composer, IT Researcher, Blacksmith
Current hardware:
OASYS 88 (EXs1-3, STR-1, LAC-1, MOD-7, EXb-DI), Haken Continuum (½), Alesis A6 Andromeda, Novation Supernova II ProX, Doepfer A-100 BS2, PC, 220lbs Anvil, 3.3lbs Hammer.
Composer, IT Researcher, Blacksmith
Current hardware:
OASYS 88 (EXs1-3, STR-1, LAC-1, MOD-7, EXb-DI), Haken Continuum (½), Alesis A6 Andromeda, Novation Supernova II ProX, Doepfer A-100 BS2, PC, 220lbs Anvil, 3.3lbs Hammer.