a question on PCM in relation to USER PADS

nabil_kh2 · Post by **nabil_kh2** » Sat Dec 27, 2008 1:12 pm

Hi guyss

I loaded some user pads from a set i got today,
they work fine when i load the whole set but wen i load just the user pads with my set it doesnt work, only a few of them work.
Now my question is is this problem because i havnt loaded the pcm, f it is
is there a way to figure out which pcm is for the pads.
If this isnt the problem then can u tell me wat is so i can fix it.

thankssssss

BasariStudios · Post by **BasariStudios** » Sat Dec 27, 2008 1:22 pm

karmathanever · Post by **karmathanever** » Fri Jan 02, 2009 4:41 am

If the pads you are loading use SOUNDs which require RAM samples, then you must load those SOUNDs to get the PCM files loaded correctly - then your pads should work...

Hope this is what you are referring to...

Cheers

Pete