Page 1 of 1
Moog type sound on TR
Posted: Wed Mar 25, 2009 12:04 am
by Abierto
Hi everybody! does somebody know how to make a sound like this one, on a korg tr, that's in this video? (you can hear it in the intro, but don't care about the strings sound... only the moog type sound)
http://www.youtube.com/watch?v=yzSRFsunTRM
Please help me! i can't make it T_T
Posted: Wed Mar 25, 2009 9:42 am
by Synastikki
http://www.progsounds.com/forum/f25/tri ... nosaw-t800
with a little tweaking (mainly just changing the cutoff) this sound gets pretty close. If you can use the MS-20 samples for the lead (
http://www.progsounds.com/forum/f25/tri ... mples-t798) if you can't use external samples replace the samples in the program with some saw waveforms (on my Triton Classic Saw-MG3 sounded quite good)
Posted: Wed Mar 25, 2009 10:57 pm
by Abierto
thank you! sounds perfect!
*.*
Posted: Sat Apr 04, 2009 7:17 pm
by Baldix
...only for TR or also for Triton Le 61?
Posted: Sat Apr 04, 2009 9:14 pm
by X-Trade
they are more or less identical except that the TR has an expanded sample set, and takes SD card rather than SmartMedia. TR also has a few presets
synth engine and I believe all other parameters are the same.
so this should work for both
Posted: Fri Apr 10, 2009 3:04 am
by bmstylee
dumb question. how do i get that into a usable media for my board. do i use the sd card on my tr or what? not really sure. i have always used and tweaked the sounds on the boards i have.
Posted: Sat Apr 11, 2009 11:34 am
by Abierto
use SD card.. something you can load without the ram... some things that are sampled, you need the ram..
Posted: Thu Apr 16, 2009 2:17 am
by bmstylee
thanks, will have to get that working. it is a cool sound.
Posted: Sun Aug 30, 2009 7:17 am
by Mersip
I'm really keen to get this sound on my TR (I love the Moog sound), and I've downloaded the file to my computer and "unzipped" it. I've then put the .PCG file onto an SD card but the TR won't load it. Can anyone help? Do I need RAM for this?
Posted: Sun Aug 30, 2009 6:37 pm
by Synastikki
it doesn't load on your board or the program won't sound? What does your keyboard say when you try to load it?
Posted: Mon Aug 31, 2009 8:03 am
by Mersip
I've managed to load the file in two different ways, but neither of them generates any sound once I swtich to Prog mode. In Media, I went down through the menu tree on the SIM card until I found the lowest level file PRG CLASSIC MONOSAW and loaded that into PROG A002. I switch to Prog and it shows the name Classic MonoSaw but no sound is generated. I then went back into Media and went up a few levels in the file tree and tried loading CLMOMOSW.PCG using the "Load Selected" option but it said "There is no readable data". However, it did allow me to load this using "Load PCG (RAM) and Samples" (note I don't have RAM). Again, when I switched to Prog 002 the file name showed Classic MonoSaw but no sound was generated.
Any thoughts?