How can I send / receive midi data on "Tone Adjust"

coucou · Post by **coucou** » Tue May 19, 2009 11:39 pm

Hi,

Please help I am trying to record in an external sequencer some parameters such as VPM Ratio1, VPM Ratio 2 moving the knobs in Tone Adjust, but it does not send midi data. In "R Time" I can not select these parameters either.

Is there any means to send midi data for parameters in the Tone Adjust?

Btw: A hint for sound excellence. I have my Oasys synched to the WC from the Prism Orpheus and SPDIF out to the SPDIF in of this converter to avail its marvellous DAC. The sound is unbeliable!. There is a big difference when clocking the Oasys in WC rather than from the SPDIF in signal.

Cheers
Robert

Post by **Sharp** » Wed May 20, 2009 2:20 pm

I don't use software sequencers, but don't you have to record SySex here ?.
For example, assign something you wish to edit to a Knob and record the SySex that generates into your software Sequencer.

That's if there is not a CC# value you can already adjust for what you want to edit.

Regards
Sharp.

danatkorg · Post by **danatkorg** » Thu May 21, 2009 11:12 pm

For info on Tone Adjust and MIDI, see "0–9f: Tone Adjust" on page 26 of the Parameter Guide (latest PDF version, E5). Also, make sure that SysEx is enabled both on the OASYS, and in your external sequencer.

Best regards,

Dan

coucou · Post by **coucou** » Fri May 22, 2009 1:45 am

Thanks a lot!!!
Cheers
Robert