Page 1 of 1
tr-rack sysex
Posted: Fri Jun 19, 2009 12:23 pm
by jpq
tr-rack sysex its normal is very slow in sending sysex to computer ?
i in emagic editor (OLD trinity speffic) some times seems tr-rack dont responding. ps. i manual there is i know talked recive times are very long. and seems it its.
Re: tr-rack sysex
Posted: Fri Jun 19, 2009 1:24 pm
by jpq
Something odd data transfer to computer makes in this software error like tr-rack not responding. or something similar.
Posted: Fri Jun 19, 2009 1:46 pm
by jpq
Now seems problem is sending data to computer but not computer to tr-rack.
Posted: Fri Jun 19, 2009 6:26 pm
by jpq
What is wrong ? i think i tested so many numers (i mean these delays etc what i can set) with emagic editor. and now i even changed midi cable. i going think i use only presets if this is so hard. and looking how multi mode used. ps. my midi interface if means anything is emu 0404 pci card (what i also use soundcard). At least sound card is good i dont know if midi stuff is not so good.
Posted: Fri Jun 19, 2009 6:39 pm
by jpq
What is wrong ? i think i tested so many numers (i mean these delays etc what i can set) with emagic editor. and now i even changed midi cable. i going think i use only presets if this is so hard. and looking how multi mode used. ps. my midi interface if means anything is emu 0404 pci card (what i also use soundcard). At least sound card is good i dont know if midi stuff is not so good.
Posted: Fri Jun 19, 2009 6:41 pm
by Timo
I'm a bit of a midiphobe and only know and use the bare essentials, so I can't advise, sorry.
I did have serious problems transmitting sysex (patch data) to and from my Access Virus using my Motu Traveler soundcard's midi in/out, but buying a little 3-in/out Edirol UM-3EX Midi interface worked great instead.
Posted: Fri Jun 19, 2009 6:59 pm
by jpq
Now i have esi romi/o interface and tested with tr-rack i think problems are even bigger. but my yamaha s30 sends sysex stuff well). and plays softsynth well. now its seems problem is emagic editor or tr-rack.
i'll tell ya what
Posted: Wed Jul 01, 2009 12:50 pm
by Spacecowboy
i dont know lol
Re: slow response using trinitro or editor?
Posted: Wed Jul 01, 2009 4:37 pm
by jpq
Spacecowboy wrote:in one of the editors thers a place to set how much time you wanna give for the host to communicate to the other unit or from the computer to the unit. the trinity's are slow so if its set fast, you get the error message. you can ignore that message and just wait and i believe it works, or you can adjust the time so it doesnt expect it so fast and may not get the error. i just waited and all was well just ignore the error and try and click it away. been a while since i did it but i use either soundiver or trinitro cant remmeber. most likely soundiver.
Actually this dont work i used allredy times what are recommend and even longer times. and problem is synth to computer times not computer to synth times what i know are VERY SLOW. ps. in soundiver there is these time settings and i use other reasons this editor. becouse some editors dont even work and one is commercial program what is way too pricey. and some how when i star sysex sending form korg tr-rack sonar homestudio 6 gets data without problem only problem is now soundiver supports sysex but dont open these sysex files.
Posted: Thu Jul 16, 2009 2:10 am
by jpq
I now compared two files what i get form tr-rack these are different (used computer for comparing) someway i dont know how.