Korg Forums

I'm trying to capture the MIDI output of an EMX1 into Apple Logic.

I have two tracks set up in Logic, both are "External MIDI Instrument" type.
Both are set to MIDI Port 2, which is the port my EMX is on.
Track 1 is set to Channel 1, as I'm hoping to capture my 1st synth part to that track
Track 2 is set to MIDI Channel 10, as I'm hoping to capture my Drums to that (which I'd later separate to individual tracks by tone, a nice feature of Logic)

Oddly, it sems to capture both the Synth and the Drums to both tracks... I'm going to keep digging, but wondered if someone knew an obvious thing I'm missing, like "oh, you gotta go into MIDI prefs and turn off yatayata"...

anyone been dow this road before?

thanks in advance,
/Joe

Hmm hate to tell you, logically speaking you are doing it exactly right.... it's gotta be something you're doing wrong in the software.... I am not very familiar with logic so on your own sorry bro!

Good luck!