start / stop internal clock?

Lodger · Post by **Lodger** » Fri Oct 23, 2009 7:19 am

Hi!
I have a question concerning the internal clock of the KP3.

When I have loaded my 4 samples from the SD card with all settings [ALL], the KP3 automatically starts to 'run' after all samples have loaded.
In my band I want - at some point - to start with the KP3 loop in the middle of a song, but then it is possible that when I push a sample button, the internal clock is somewhere in the middle of a loop.

Is it possible that the clock only starts running when I press / switch on the first sample?

Hope someone can help.

xmlguy · Post by **xmlguy** » Fri Oct 23, 2009 11:56 am

Shift+Tap, to realign. You can also look at the different loop modes that are available in the 2.0 version of the operating system. The modes are described in the documentation that come with the OS update.

Lodger · Post by **Lodger** » Fri Oct 23, 2009 12:38 pm

Okay, I'll install 2.0 first.
Basically, what I want is that the Tap-knob starts blinking when I hit the first sample button, not before. Is that possible in OS 2.0?

Lodger · Post by **Lodger** » Fri Oct 23, 2009 12:41 pm

I guess "Type 3" should do the trick!

Thanks for the tip, xmlguy!